Dell Wyse C class WES2009 software Guide d'installation télécharger pdf (Page 9)

Installing Flash and RAM 5

2. Install the new flash module in the reverse order of removing the original flash module.

Carefully press the flash module onto the standoff lock and connector, making sure to

lock it into place.

Step 3: Install the RAM Module

Warning

RAM modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis

and keep that contact with the chassis during the installation process.

1. Note where the connector of the RAM module is located in Figure 4. Remove the

existing RAM module. Use your fingers to unlock the two retaining clips at either side of

the RAM module by pushing in the direction of the arrows shown in Figure 4. The

module should pop up from its socket. Lift out the RAM module.

Figure 4 Removing the existing RAM module

2. Install the new RAM module in the reverse order of removing the original RAM module.

Carefully press down on the RAM module until its retaining clips lock it into place.

Step 4: Reassemble the Cloud Client

1. Replace the top cover in the reverse order as described in "Step 1: Remove the Top

Cover."

2. Attach any support feet.

3. Reconnect the video display, keyboard, mouse, network cable, and power adapter to

the cloud client before connecting to an electrical outlet.

Caution

Do not turn on the cloud client. The cloud client is ready to re-image,

however the flash module does not contain an operating system. Turning on

power to your cloud client without firmware will display the error message

“NO OPERATING SYSTEM FOUND.”

What’s Next

Continue with "Installing WES2009 Firmware."

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

Dell Wyse C class WES2009 software Guide d'installation Page 9