Dell Wyse WES7 conversion kit for Z class Guide d'installation télécharger pdf (Page 7)

2 Installing Z Class Flash

This chapter contains information for users of Wyse Z class thin clients who must install

new flash. If you are installing firmware only, you can skip this chapter and proceed to

"Installing WES7 Firmware."

Requirements

• Small Phillips screwdriver

Warning

Flash modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis

and keep that contact with the chassis during the installation process.

Procedures

Caution

Follow all precautions listed in the Quick-Start Guide that came with your thin

client for disconnecting and reconnecting the thin client.

1. Perform a proper shutdown of the thin client by closing all files and ending your

session, and then pressing the power button to turn off the thin client.

2. Unplug the power cord and power adapter, and remove any other cables from the thin

client, and detach the vertical foot.

3. Position the thin client horizontally, where the Wyse logo-side with four flat screws is

facing downward. Using the Phillips Screwdriver remove the two screws from either

end near the back panel, and then remove the three screws from the cover along the

back panel edge, as shown in Figure 2.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Dell Wyse WES7 conversion kit for Z class Guide d'installation Page 7