Dell Wyse WES7 conversion kit for Z class Guide d'installation télécharger pdf (Page 9)

Installing Z Class Flash 5

Figure 4 Removing the cover

6. Remove the cover to expose the flash module, as shown in Figure 5.

Warning

Flash modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis

and keep that contact with the chassis during the installation process.

7. Remove the existing flash module. Locate the flash module and use the Phillips

Screwdriver to remove its retaining screw as shown in Figure 5. Lift the flash module

out of the socket.

Figure 5 Removing the existing flash module

8. Install the new flash module in the reverse order of removing the original flash module.

Carefully screw down its retaining screw until it is secure.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Dell Wyse WES7 conversion kit for Z class Guide d'installation Page 9